DIN 705 - 2007 Adjusting Rings

Unit: 毫米(mm)

Nominal Diameter

2.5

d	min=nominal size (H8)
	max
b	Nominal Size (js14)
	max
	min
d_c	max=nominal size (h13)
	min
d₀
d₁	min=nominal size (H11)
	max
Screw Size ^①	set screw
grooved pin ^②
taper pin ^②
per 1000 units ≈ kg	Form A
	Form B / Form C

2	2.5	3
2.014	2.514	3.014
3.5	4	5
3.65	4.15	5.15
3.35	3.85	4.85
6	7	7
5.82	6.78	6.78
M2	M2	M2
0.6	0.8	0.8
0.66	0.86	0.86
M2×3	M2×3	M2×3
/	/	/
0.6×6	0.8×6	0.8×6
0.69	1.05	1.23
0.65	0.96	1.15

①,In contrast to grooved and tapered pins, grub screws (up to M10 with slot according to DIN EN 27434 and AB M12 with hexagon socket according to DIN EN ISO 4027) are part of the adjusting ring.
②,Grooved pins: According to DIN EN ISO 8744. Instead of tapered grooved pins according to DIN EN ISO 8744, dowel pins according to DIN EN ISO 8752 or spiral dowel pins according to DIN EN ISO 8750 may also be used. taper pins: If taper pins according to DIN EN 22339 are used, the hole must be reamed with a 1:50 taper when mounting.
③,Mateial: a)Steel, Material group: Free cutting steel; Hardness: 100 HV to 175 HV Standard DIN EN 10087 b)Stainless steel, Material group: A1; Hardness: 140 HV to 240 HV Standard DIN EN 10088-3 c)Non-ferrous metal, Material group: CU3 Standard DIN EN 28839