Unit:
|
| ①,The extent of rounding or flat at the apex of the cone point shall not exceed an amount equivalent to 10% of the basic screw diameter. ②,When specifying nominal size in decimals, zeros preceding the decimal and in the fourth decimal place shall be omitted. ③,Point angle α shall be 90 deg. (± 2°) for screws of nominal lengths equal to or longer than those listed for variable Y, and 118 deg. (± 2°) minimum for screws of shorter nominal lengths. |
Slotted Set Screws with Cone Point
Suppliers(1)
Slotted Set Screws with Cone Point
Suppliers(1)
Slotted Set Screws with Cone Point
Slotted Set Screws with Cone Point
Slotted Set Screws with Cone Point
Slotted Set Screws with Cone Point
Slotted Set Screws with Truncated Cone Point
Slotted Screws with Truncated Cone Point
Slotted Set Screws with Cone Point
Slotted Set Screws with Cone Point
Slotted Set Screws with Cone Point
Slotted Set Screws with Cone Point
Flat-point Straight Slotted Set Screws. Product Grades А and В
Slotted Set Screws with Cone Point
Slotted Set Screws with Cone Point (A307, SAE J429, F468, F593)
Slotted Set Screws with Cone Point
